Common causes are a dirty filter, frozen coil, low refrigerant, a failed capacitor or a dirty outdoor coil. Turn the system off if you see ice and call us.
As a rule, if a repair costs more than a third of replacement and the unit is over 12 years old, replacement usually saves money.
Restricted airflow or low refrigerant is the usual cause. Switch to fan only to thaw it, then have it diagnosed so it does not repeat.
Costs depend on the diagnosis and parts required. We explain the work and provide a quote before repairs begin.
Timing depends on the equipment, home and scope of work. Ask for an estimated schedule before work begins.
Permit requirements vary by location and project. Confirm local requirements and who will handle permits before work begins.
System sizing depends on the home and its existing equipment. Ask what assessment is appropriate for your project.
Service life depends on equipment, maintenance, usage and environment. Consider the system's age, condition, recurring repair needs and comfort when comparing options.
It may be in defrost mode, low on refrigerant, or have a failed reversing valve. A short burst of cool air is normal during defrost.
No. Covers trap moisture and invite pests. Keep the unit clear of debris instead.
Twice a year. Fall service confirms the heating side works before the first cold front.
It may be in defrost mode, low on refrigerant, or have a failed reversing valve. We diagnose it on the spot.
Check it monthly and replace it when it is dirty. The right interval depends on the filter, pets and dust.
It can identify issues such as clogged drains and dirty coils before they cause system problems.
No. The $45 tune-up is a one-time visit. Call us to discuss future maintenance.
Twice a year: once before cooling season and once before heating season. Systems run almost year-round here.
A duct blaster test measures total leakage. Visible gaps, dust streaks and uneven rooms are warning signs.
It can remove built-up dust and debris, though filtration and humidity control matter as much.
Flexible duct typically lasts 15 to 25 years, less in very hot attics.
Yes. In attic duct systems, leaks can waste a quarter of the air you pay to cool.
It removes moisture independently of cooling, keeping humidity in the healthy range even in mild weather.
They are effective at controlling growth on the coil, where moisture collects. They are not a cure-all.
MERV 8 to 11 suits most systems. Higher ratings can restrict airflow unless the system is designed for them.
Between 40 and 55 percent. Higher levels invite mold and make the house feel warmer than the thermostat says.
Call to discuss availability and request a quote before scheduling.
Timing depends on call volume and distance. Ask about the next available appointment when you call.
Once power is restored, a technician can assess the system if it is not operating normally.
Availability depends on call volume and location. Call us to discuss the next available appointment.
Tell us what is going on and we will discuss service options. You receive a written quote before work begins.
For service or an estimate, call (239) 645-1620.
